Castle XLX ESC Mounting Plate For Arrma Infraction V2 - Complete Kit

Description

USA Made
Here In California!
Mounting Plate Kit to Fit Castle XLX to the Arrma Infraction V2. The Kit Comes with pre-drilled mounting plate, and all fixings needed to fit your mamba XLX to the Arrma Infraction. This Kit lets you
RETAIN THE ORINGINAL RED CENTRE BRACE! ALSO MEANS THE HANDBRAKE KIT WILL FIT WITHOUT FOULING!
This mounting plate enables you to mount your castle XLX ESC above the center diff (With screws! Not Tape!).
ESC FITS WITH THE STOCK BODY INPLACE
. It comes with a 4mm thick Aluminum plate, which mounts on four spacers (included) and is held down by four stainless steel screws (Included). The XLX esc is then held to the plate with 4 screws & nyloc nuts (All included). Once in place the sliding motor mount can STILL be accessed (See pic) to change the pinion.
We also sell extension wires - check out our 6.5mm leads here - https://www.ebay.com/itm/153524152303
And our 8mm Male to 6.5mm Female leads here - https://www.ebay.com/itm/153704988718
This kit DOES NOT come with a Castle XLX included!
However If you fit a Castle XLX esc you will have no more over heating issues and be able to run an 8S motor if needed.
To fit the kit simply remove the existing four screws in the top of the center diff, place the long screws through the countersunk holes on the Aluminum motor mount, then put
the spacers over the long screws so as to mount the plate over the centre brace. Line the screws up with the holes on the centre diff cover. Tighten all four screws until plate is secure, and the plate is flush. Then mount castle esc on top of the plate using the m3 screws & nyloc nuts (Both included).
FREE SHIPPING BY FIRST CLASS MAIL. Priority Mail available as an extra cost option (Must select at checkout)